Energy efficiency assessment of centrifugal pump control using a frequency converter, considering static head and losses in the electric drive

Authors

  • Musurmonov Tokhirjon Fergana State Technical University image/svg+xml Author
  • Urishev Omadjon Fergana State Technical University image/svg+xml Author

Keywords:

centrifugal pump, variable frequency drive, frequency converter, induction motor drive, throttling control, affinity laws, static head, energy efficiency, mathematical modeling

Abstract

The paper evaluates the energy efficiency of flow control in centrifugal pump units by a variable frequency drive (VFD) with allowance for the static head of the pipe system and the losses in the drive. A steady-state mathematical model is developed that combines the pump and system curves, the affinity laws, and loss models of the induction motor and the frequency converter; dimensionless relations for the required speed, the throttling loss and the hydraulic power are derived from it, and the calculations are carried out in Python. It is shown analytically that the cube law is a special case of the model that holds only for a system without static head, whereas in the general case part of the power decreases only in direct proportion to the flow rate. When the static head share increases from 0 to 60 %, the annual energy savings decrease from 47.6 % to 27.0 %, while the cube law widely used in practice gives about 49 % in all cases and overestimates the savings by up to 22 percentage points. The contribution of drive losses is about 1.5 percentage points. Static head is thus the main factor determining the savings; therefore, at the design stage it is recommended to rely on a model that accounts for the system curve rather than on the cube law

References

1. Shankar V.K.A., Umashankar S., Paramasivam S., Hanigovszki N. A comprehensive review on energy efficiency enhancement initiatives in centrifugal pumping system // Applied Energy. - 2016. - Vol. 181. - P. 495-513. - DOI: https://doi.org/10.1016/j.apenergy.2016.08.070

2. Ferreira F.J.T.E. [et al.] Ecoanalysis of variable-speed drives for flow regulation in pumping systems // IEEE Transactions on Industrial Electronics. - 2011. - Vol. 58, № 6. - P. 2117-2125. - DOI: https://doi.org/10.1109/TIE.2010.2057232

3. Soobrayen D., Jahmeerbacus I., Caremben P. Comparative study of throttling and variable speed drive operation of parallel pumps for cooling stations in sugar production // 2022 4th International Conference on Emerging Trends in Electrical, Electronic and Communications Engineering (ELECOM). - 2022. - DOI: https://doi.org/10.1109/ELECOM54934.2022.9965256

4. Oshurbekov S., Kazakbaev V., Prakht V., Dmitrievskii V., Gevorkov L. Energy consumption comparison of a single variable-speed pump and a system of two pumps: variable-speed and fixed-speed // Applied Sciences. - 2020. - Vol. 10, № 24. - Art. 8820. - DOI: https://doi.org/10.3390/app10248820

5. Gevorkov L., Šmídl V., Sirový M. Model of hybrid speed and throttle control for centrifugal pump system enhancement // 2019 IEEE 28th International Symposium on Industrial Electronics (ISIE). - 2019. - P. 563-568. - DOI: https://doi.org/10.1109/ISIE.2019.8781218

6. Hieninger T., Goppelt F., Schmidt-Vollus R., Schlücker E. Energy-saving potential for centrifugal pump storage operation using optimized control schemes // Energy Efficiency. - 2021. - Vol. 14, № 2. - Art. 23. - DOI: https://doi.org/10.1007/s12053-021-09932-5

7. Kan E., Mukhammadiev M., Ikramov N., Majidov T. Full-scale testing of the pump unit with a frequency converter // IOP Conference Series: Materials Science and Engineering. - 2020. - Vol. 883. - Art. 012112. - DOI: https://doi.org/10.1088/1757-899X/883/1/012112

8. Wang G., Wang Z., Han Z., Diaz Rodriguez R. Investigation of efficiency models in EnergyPlus and AMCA standard 207 for induction motors powered by variable frequency drives // Energy and Buildings. - 2019. - Vol. 196. - P. 94-102. - DOI: https://doi.org/10.1016/j.enbuild.2019.04.045

9. Yi J., Li C., Zhang D., Li X. A fast and accurate loss model of converter-fed induction motor in central air-conditioning system // IEEE Transactions on Power Electronics. - 2023. - Vol. 38, № 3. - DOI: https://doi.org/10.1109/TPEL.2022.3222605

10. Dinolova P., Ruseva V., Dinolov O. Energy efficiency of induction motor drives: state of the art, analysis and recommendations // Energies. - 2023. - Vol. 16, № 20. - Art. 7136. - DOI: https://doi.org/10.3390/en16207136

11. Abdullabekov I., Sapaev Kh. An energy efficient control system for water lifting units of the Ramadan pumping station based on frequency controlled electric drives // AIP Conference Proceedings. - 2023. - Vol. 2552. - Art. 040023. - DOI: https://doi.org/10.1063/5.0130676

12. Abdullabekov I.A., Mirsaidov M.M., Zaripov O.O., Nimatov S.J., Eralieva Yu.M. Reducing reactive energy consumption by optimizing operating modes of irrigation pumping stations // E3S Web of Conferences. - 2024. - Vol. 486. - Art. 06017. - DOI: https://doi.org/10.1051/e3sconf/202448606017

13. Sapaev Kh., Umarov Sh., Abdullabekov I., Khamudkhanova N., Nazarov M. Scheme of effective regulation of pumping station productivity // AIP Conference Proceedings. - 2021. - Vol. 2402. - Art. 060016. - DOI: https://doi.org/10.1063/5.0071557

14. Semenov A. [et al.] Optimization of pump unit electric drives in water supply systems based on frequency control // Bulletin of the National Technical University “KhPI”. Series: Energy: Reliability and Energy Efficiency. - Kharkiv, 2025. - URL: https://repository.kpi.kharkov.ua/handle/KhPI-Press/99776

15. Zakladnyi O. Vladimir P. Comprehensive assessment of energy efficiency of pumping equipment with adjustable drive // Power Engineering: Economics, Technique, Ecology. - 2025. - DOI: https://doi.org/10.20535/1813-5420.2.2025.329529

16. Fouda Y.M. A selection method of variable speed centrifugal pumps for maximum hydraulic efficiency // Journal of the Brazilian Society of Mechanical Sciences and Engineering. - 2023. - Vol. 45, № 11. - DOI: https://doi.org/10.1007/s40430-023-04481-7

17. Gülich J.F. Centrifugal Pumps. - 4th ed. - Cham: Springer, 2020. - 1264 p. - DOI: https://doi.org/10.1007/978-3-030-14788-4

18. Turkeri C., Kiselychnyk O. Dynamical modelling of a centrifugal fan driven by an induction motor and experimental validation // Energies. - 2023. - Vol. 16, № 18. - Art. 6658. - DOI: https://doi.org/10.3390/en16186658

Downloads

Published

27.09.2026

Issue

Section

Articles

How to Cite

Musurmonov, T., & Urishev, O. (2026). Energy efficiency assessment of centrifugal pump control using a frequency converter, considering static head and losses in the electric drive. Bulletin of Contemporary Researches, 2(4), 27-35. https://bulconre.com/index.php/mult/article/view/37